Locate swashplate and slide it on the
main shaft first. Install pivot balls as
shown in the picture.
Next locate the washout base, arms,
links, M3x4 pivot studs, M3x10 cap
head screws, M3x5x1 spacers, M3 set
screws, and washout link pins. First
slide an M3x10 cap head screw
through each arm. Note which
direction the screw should go through
the arm in the picture. Slide an
M3x5x1 on each bolt and attach them
to the base. Next attach an M3x4 pivot
stud to each of the washout arms.
Finally attach a washout link to each
arm with a link pin and set in place with
set screw. Next slide the washout onto
the main shaft with the protruding side
going down first.
Attach the washout links to the pivot
studs on the inner ring of the
swashplate.
Slide the Antirotation guide pin on the
main shaft next. Secure it using the
M3x3 set screw. This will be adjusted
later, so snug is all this screw needs to
be for now.
