Attach the antirotation upright
piece to the antirotation base
using (2) M3x6 cap head
screws.
Attach the antirotation guide
using (4) M3x6 cap head screws
and (4) M3 washer.
Assemble the rear sub-frame as
shown. Attach the two frame
halves with the boom holders.
They will be attached using (4)
M3x35 cap head bolts and nuts
Next you will attach the rear
sub frame to the helicopter.
There are eight attachment
points, four on each side. Take
an M3x20 cap head screw and
slide it through the hole on the
frame. Next, slide a 10mm
spacer onto each of the bolts.
Slip the sub-frame into the
middle and secure each bolt
with a 24mm cross member in
the middle.
Landing Gear Installation
Parts List
Landing Gear Struts X 2
Landing Gear Skids X 2
Landing Gear Skid Ends X 4
M3x3 Set Screws x 4
M3x14 cap head screws x 4
M3 locknuts x 4
