Slide the main shaft down
through the autorotation hub.
Secure it in place with an
M3x18 cap head bolt and M3
locknut. Then secure the main
shaft on top with the main shaft
collar and (4) M3x3 set screws.
This is how the helicopter
should look at this point.
Section 3 – Counter Gear Assembly
Parts List
Bag 3
Counter Gear Shaft x 1
Counter Gear x 1
Lock Pin x 1
E-Clip x 1
Counter Gear Bearing Block x 2
Pulley Gear Plate x 1
Lock Pin x 1
Pulley Gear x 1
E-Clip x 1
M3x6 Cap Head Screw x 8
M3 Washer x 8
Install the steel stopper
pin into the counter
gear shaft. Then slide
the counter gear onto
the counter gear shaft.
