Install two 7x13x3 o-rings into the head
block. Next slide the head spindle through
the o-rings. Then slide the head dampener
spacers onto the spindle
Each blade grip will have (2) 5x10x4R
bearings. Install the bearings into the blade
grips. Slide each one onto the spindle shaft.
Secure the blade grips to the spindle using
(2) M3x10 cap head screws. Place a 3x8x1
spacer under each bolt before installing them.
Attach each hiller arm to the blade grip using
an M3x10 cap head screw. Put the bolt
through the hiller arm and put a 3x5x1 spacer
on the bolt next, and screw it into the blade
grip.
Note that the open side should be towards
blade grip. Do this before mounting the
spindle.
Slide the flybar through the seesaw.
20
