15
INSTALLATION
EN
QUICK SPA
QCC CLG30 RGBW - REV001B
HOW TO REPLACE THE SPOTLIGHT UNDERWATER
(Only with thru-hull installation)
Boat interior
1. Disconnect the light body from the junction box con-
taining the driver.
2. Remove the cap and the cable outlet gasket.
3. Fit the transparent rubber tube (minimum inner Ø: 22
mm). First fit the cable in, then, secure it to the thru-hull
bolt by means of a metal clamp.
4. Fix the free end of the tube above the waterline.
Boat exterior
5. From outside the vessel, remove the three screws that
fix the light body. If needed, prise between the two ele-
ments A and B to detach the light body from the hull.
• Slide off the light body plus its cable and take it out of the
water. Be careful not to lose the screws, grower washers
and O-ring.
• Take the new light body and fit the 3x66 O-ring in the
cable as a first step.
• Always from outside, fit the cable in the thru-hull fixing
and push it into the rubber tube already fitted to the thru-
hull fixing.
• Draw the light body close to the thru-hull plate; be careful
that the O-ring is correctly fitted in the specific seat. Use
the three screws and the three grower washers to fasten
everything to the hull.
Boat interior
• Remove the rubber tube paying attention to the residual
water that may have remained inside it.
• Refit the gasket and the cap to the cable; screw it to the
cable outlet to lock it.
LIGHT BODY
THRU-HULL
PLATE
1
2
3
5
4
JUNCTION BOX
WITH INTERNAL
DRIVER
COVER
GASKET
RUBBER
TUBE
O-RING
3X66
A
Restore the electrical connections. Refer to the section “CONNECTION DIAGRAM” on page 16.
B
