14
EN
QUICK SPA
QCC CLG30 RGBW - REV001B
INSTALLATION
INSTALLATION WITH A THRU-HULL FITTING
ELEMENTS FOR EXTERIOR
ASSEMBL
Y
ELEMENTS FOR INTERIOR
ASSEMBL
Y
MAX HULL THICKNESS 78 mm
HULL HOLE
Ø 22 mm
LIGHT BODY
THRU-HULL
PLATE
THRU-HULL
FIXING
O-RING
3X45
CABLE
OUTLET
KEEP THE
ADHESIVE LABEL
UPRIGHT
CABLE
1° WASHER
2° WASHER
CONNECTING HOLE
FOR A SACRIFICIAL
ANODE
NUT
SCREW
STOP NUT
Boat exterior fig. 1
• Prepare the hull as described on pages 4 and 5.
• Fit the 3x45 O-ring to the thru-hull plate. Be careful you fit
it correctly in its seat.
• Pass the cable and the light body through the hull hole.
Gently turn the light body so as to evenly distribute the
sealant. Remove any excess sealant.
Boat interior fig. 2
• Fit the 1
st
washer to the thru-hull fixing.
• Fit the 2
nd
washer, the 3 screws, the 3 nuts and the stop
nut.
WARNING: The two washers should not be very
close one to the other. Duly adjust the screws but do
not tighten them too much or the hull wall may break.
• Once the right distance between the two washers is obtained, fix the screws with the nuts. Be careful not to turn them
still further.
• Carefully inspect the installation so as to make sure that the sealant and the O-ring fully seal the product.
If in doubt, repeat the steps to install the product again.
• Apply a suitable anti-fouling paint coat to the metallic bezel exposed to water.
FIG.1
FIG.2
Pay attention to the direction of the product. Take the
adhesive label affixed in the light body as reference.
• Apply a continuous line of a suitable sealant around the
thru-hull plate (as shown in the sketch).
F
Finish the installation by carrying out the electrical connections. Refer to the section “CONNECTION DIAGRAM” on page 16.
