14
04.10.2021
20210927 QC-PC-PID-01-Bedienungsanleitung engl.
PARAMETER-MENU
The
PARAMETER-MENU
is password protected.
To access the
PARAMETER-MENU
, the password must be entered correctly and confirmed with
. If the password is incorrect, the system jumps back to the
MONITOR
-menu. In the delivery
state, the password is 0000.
The dynamic properties of the control are set in the
PARAMETER-MENU
and the output voltage for
the connected Peltier element is adjusted.
Attention:
Parameter changes only become effective after pressing the touch-sensitive area (*
see figure below).
Two freely selectable temperatures can be set in the
PARAMETER-MENU
. The
and
buttons change the target temperature to these values. Current, voltage, setpoint and actual value
are continuously displayed so that the control can continue to be monitored. The parameterization
can be evaluated based on the temperature and readjusted if necessary. These two jump buttons are
a useful aid when parameterizing the control loop. When you exit the
PARAMETER-MENU
, the
original setpoint of the temperature is accepted again.
In the
PARAMETER-MENU
, the controller can be adapted to the connected temperature control
system. The controller has a PID-regulation characteristic. When the
PARAMETER-MENU
is entered,
the currently set control status is retained.
TAR-TEMP
shows the set target temperature. When you
reach the
PARAMETER-MENU
, the first digit of the proportional gain
KP
flashes.
KP
flashes
increases the flashing digit
decreases the flashing digit
jumps to the next digit
changes to the next line (from
KP
to
PM
and back to
KP
)
* Touch-sensitive area. Touch
here to make the parameter
change effective.
