![background image](http://html1.mh-extra.com/html/quick-mill/04005/04005_operating-instructions-manual_3641426014.webp)
14
B) The machine does not dispense coffee:
- No water in the tank; restore the water level.
- The boiler was not filled.
- Overheated coffee pump, wait for thermal protector reset.
C) The machine does not dispense hot water or steam:
- No water in the tank; restore the water level.
- Overheated hot water/steam pump, wait for thermal protector reset.
- Clogged nozzles; clean steam wand nozzles.
E) Irregular coffee dispensing:
- Clean the filter found in the filter holder.
- Coffee grinding too fine or too coarse.
For all other types of defect or unspecified problem, unplug the power-supply plug, do not carry out
repairs or checks on your own and contact a qualified technical service centre.
11.
TERMOPID functional technical specification
1.1 PROGRAMMING SET-POINT OF TEMPERATURE
Press the button
When the display shows
PrG
, press the button
When the display shows the setpoint, set with the buttons
and
the desired temperature value, from a
minimum of
85C°
to a maximum of
105C°
.
After 3 seconds from the last button pressing, the data are saved and the display shows the temperature.
1.2 PROGRAMMING ADJUSTMENT PARAMETERS
Switch on the machine through the main switch 1 by pressing buttons
and
at the same time.
When the display shows
F.03
, release the buttons.
Button
slides the parameters.
Button
enters the programming menu.
Inside the programming menu, the buttons
and
change the data; after 3 seconds from the last button
pressing, the data are saved by quitting the programming menu.
List of parameters
Parameter
Display
Description
F.03
ºF
Unit of measurement: degrees Fahrenheit
ºC
Unit of measurement: degrees Celsius