Chapter 2: Quick Tutorial
9
Viewing Information with the IAQ Monitor
Turn the IAQ Monitor on and then press and release the UP
ARROW button repeatedly to scroll through each of the following,
one screen at a time:
• Programming Menu Screen
• Recorded Data (if applicable)
• Recording Status, Memory Left, Elapsed Recording Time
• Battery Status, Present Date and Time, Test #
• Toxic Gas and Analog Channels (if enabled)
• Main Menu (present readings on CO
2
, Temperature and
Humidity channels)
Start and Stop Recording
1. Turn the IAQ Monitor on and wait for the readings to stabilize
(about 2 minutes).
2. Press and release the RECORD button. The following Screen
will appear:
Enter Secure Mode?
Press RECORD For Yes
Press
▲
/
▼
For No
ON/OFF Aborts
3. Press
the
▲
or
▼
key.
4.
The IAQ Monitor will momentarily display “Standby” while
initializing the session. The IAQ Monitor will then display the
present readings with an "S" in the upper left corner of the
display. After the session initializes, the IAQ Monitor will
display an "R" in the upper left corner of the display to
indicate that recording is in progress.
5.
To stop recording, press the RECORD button again. The
unit will display “Recording Stopped” briefly. The present
readings screen will appear with an “N” in the upper left
corner, indicating that the unit is not recording.
NOTE:
If using Survey Mode, when the RECORD button is
pressed, the IAQ Monitor will record one sample, display
"Data Sample Complete" and then stop recording.
