C Push the power cable, communication cable and video cable through the bracket tube,
leaving long enough cables for connection;
D Fix the bracket firmly on the wall with three M5 screw nuts and washers.
或200
出线槽
Installation of high Speed Dome Camera
a.
Unpacking the carton and carefully take out the dome camera and its attachments, open
the vitreous cover and take out the fillings.
b.
Loosen the M3 screws connecting the camera and the outer housing, and swivel the camera
left for 15 degrees and remove it. Check cable connectors and see if any of them loose and setup
the coding switch.
c Restore the plastic washer to the camera, then tighten the installation of camera and outer
housing according to the installation instructions of the camera;
d.
Insert the connecting cables into the bracket tube, then push the tube screw on the top of
the outer housing into the suspending bracket, fix it on the bracket with 3 M6 screws.
Connection of Exterior Cables
Connect BNC video outlet of the dome camera with the already disposed video cable, the
power cable with the already disposed power cable (DC14V) and RS485 controlling cable with
already disposed RS485 controlling cable. The signal cable of high speed dome camera is shown
below:
Cable
Application
Connecting Objects
Remarks
Power
cable
DC14V or
AC24V power
supply
high speed dome-power
supply adapter
green, white
485
cable
485 controlling
signal
high speed dome -
controlling device
red
（
A
） 、
black
（
B
）
Video
Camera signal
Camera-monitoring device BNC connector
400 or 200
Cable slot
