Smart LTE Module Series
SC600Y&SC600T Hardware Design
SC600Y&SC600T_Hardware_Design 77 / 128
3.21.1. Design Considerations
⚫
Special attention should be paid to the pin definition of LCM/camera connectors. Assure the
SC600Y&SC600T
and the connectors are correctly connected.
⚫
MIPI are high speed signal lines, supporting maximum data rate up to 2.1Gbps. The differential
impedance should be controlled as
100Ω. Additionally, it is recommended to route the trace on the
inner layer of PCB, and do not cross it with other traces. For the same group of DSI or CSI signals, all
the MIPI traces should keep the same length. In order to avoid crosstalk, it is recommended to
maintain the intra-lane spacing as trace width and the inter-lane spacing as two times of the trace
width. Any cut or hole on GND reference plane under MIPI signals should be avoided.
⚫
It is recommended to select a low capacitance TVS for ESD protection and the recommended
parasitic capacitance is below 1pF.
⚫
Route MIPI traces according to the following rules:
a) The total trace length should not exceed 305mm;
b) Control the differential impedance as
100Ω±10%;
c) Control intra-lane length difference within 0.67mm;
d) Control inter-lane length difference within 1.3mm.
Table 25: MIPI Trace Length Inside the Module
Pin No.
Pin Name
Length (mm)
Length Difference (P-N)
116
DSI0_CLK_N
20.82
-0.45
115
DSI0_CLK_P
20.37
118
DSI0_LN0_N
24.84
0
117
DSI0_LN0_P
24.84
120
DSI0_LN1_N
24.85
-0.03
119
DSI0_LN1_P
24.82
122
DSI0_LN2_N
25.94
0.24
121
DSI0_LN2_P
26.18
124
DSI0_LN3_N
29.31
0.2
123
DSI0_LN3_P
29.51
103
DSI1_CLK_N
9.52
-0.05
102
DSI1_CLK_P
9.47
