QubicaAMF XLi Pinspotter Motor and Gearbox Manual
400-088-038
31
Revision F
3.3.6
Oil Seal Replacement: Distributor Drive Shaft
Be sure to follow the procedures from Section 3.3.3 – Oil Draining before replacing any oil seal.
Tools Required
Flat-head Screwdriver
Klüber Grease (P/N 715-012-505)
Cleaner (Loxeal
®
10 or Loctite
®
7061)
Installation Tool (P/N 088-004-660)
Clean Cloth
Tape
1.
Position gearbox with distributor drive shaft upwards. Take care to not damage the sides of the
gearbox.
2.
Wrap the end of a flat-head screwdriver with insulating tape to prevent damage. Screwdriver should
be approximately 0.04” tip thickness x 0.2” tip width x 5” length (1 x 5.5 x 125 mm).
3.
Insert the screwdriver tip between the oil seal lip and the output shaft. Take care to not damage the oil
seal seat on the shaft.
4.
Use the screwdriver as a lever and the distributor drive shaft as a fulcrum to remove the oil seal from
its seat.
5.
Spray cleaner (Loxeal
®
10, Loctite
®
7061, or equivalent) on a clean cloth and carefully clean the outside
(cap) and inside seat (shaft) of the oil seal. *Never use a drying or oxidizing agent such as bleach or
brake parts cleaner as they will promote rust.
6.
Grease the NEW oil seal with Klüber grease.
7.
Place the seal onto the cover.
8.
Fit the oil seal with the appropriate plastic installation tool.
9.
Check that the oil seal fits correctly.
Caution!
Oily rags can be a fire hazard. Dispose of them in an approved metal container only!
