QubicaAMF XLi Pinspotter Motor and Gearbox Manual
400-088-038
30
Revision F
3.3.5
Oil Seal Replacement: PBL Drive Shaft
Be sure to follow the procedures from Section 3.3.3 – Oil Draining before replacing any oil seal.
Tools Required
Flat-head Screwdriver
Klüber Grease (P/N 715-012-505)
Cleaner (Loxeal
®
10 or Loctite
®
7061)
Installation Tool (P/N 088-004-660)
Clean Cloth
Tape
1.
Position gearbox with PBL drive shaft upwards. Take care to not damage the sides of the gearbox.
2.
Remove the key from the shaft.
3.
Wrap the end of a flat-head screwdriver with insulating tape to prevent damage. Screwdriver should
be approximately 0.04” tip thickness x 0.2” tip width x 5” length (1 x 5.5 x 125 mm).
4.
Insert the screwdriver tip between the oil seal lip and the output shaft. Take care not to damage the oil
seal seat on the shaft.
5.
Use the screwdriver as a lever and use the PBL drive shaft as a fulcrum to remove the oil seal from its
seat.
6.
Spray cleaner (Loxeal
®
10, Loctite
®
7061, or equivalent) on a clean cloth and carefully clean the outside
(cover) and inside seat (shaft) of the oil seal. *Never use a drying or oxidizing agent such as bleach or
brake parts cleaner as they will promote rust.
7.
Tape the PBL drive shaft all the way around to protect the keyway.
8.
Grease the NEW oil seal with Klüber grease.
9.
Place the oil seal onto the cover.
10.
Fit the oil seal with the appropriate plastic installation tool.
11.
Check that the oil seal fits correctly and remove the tape.
12.
Fit the previously removed key back into its seat in the output shaft.
Caution!
Oily rags can be a fire hazard. Dispose of them in an approved metal container only!
