QubicaAMF XLi Pinspotter Motor and Gearbox Manual
400-088-038
4
Revision F
19.
Wipe the old grease and anti-seize compound from the sweep drive shaft splines.
20.
Apply a liberal amount of anti-seize compound to the splines of the sweep drive shaft and the bore of
the output shaft of the gearbox.
21.
Install the sweep motor and gearbox assembly by aligning the splines of the sweep gearbox and the
sweep drive shaft. Push the gearbox onto the sweep drive shaft.
22.
Install and tighten the three bolts and nuts securing the gearbox to the crossbeam.
23.
Connect the sweep brake and encoder cables to the wire harness in the wire-way. Cables should pass
thru the grommet.
24.
Install the crossbeam cover.
25.
Connect the power cord to the sweep motor.
26.
Restore power to the pinspotter.
27.
Run the sweep to the home position.
28.
Cycle the pinspotter and observe for correct operation.
1.3.3
Servicing the Table Gearbox
Perform this procedure every 100,000 frames in conjunction with servicing the table drive motor.
Tools Required
Cranking Tool
2 x 4 (approximately 2-3 feet long)
Flat Blade Screwdriver
Spring Puller
9/16-inch Wrench
3/4-inch Wrench
9/16-inch Socket 3/8-inch Drive
5/16-inch Wrench
3/8-inch Drive Ratchet
3/8-inch Drive 6-inch Extension
1.
Run the table to the pin spotting height, supported on a block of wood (2 x 4).
2.
Run the sweep to the 1st guard position.
3.
Remove power from the pinspotter. Follow appropriate Lockout/Tag Out procedures.
4.
Disconnect the power cord from the table motor.
5.
Remove the crossbeam cover.
6.
Disconnect the table brake and motor encoder cables from their harnesses in the wireway.
7.
Remove the spring hangers and springs from the spot and re-spot arm link assemblies.
8.
Remove the three bolts and nuts securing the table motor and gearbox assembly to the crossbeam.
9.
Carefully slide the table gearbox assembly from the table drive shaft and move the assembly to a work
bench.
10.
Remove the three bolts and nuts that secure the table motor to the gearbox.
