I
NSTALLATION
Harmony
Ball Return Manual
–
400-254-022
26
Rev. Date 3/16
6.9.5 HOOD SWITCH CONNECTIONS:
16.
Route the hood switch cable (252-003-108) through the designated entry point and secure
with the appropriate strain relief.
17.
Connect the conductors to
JP4
HOOD-SW terminals. The connection position does not
depend on the color of the wire. See Figure 19.
6.9.6 INTRUSION SENSOR INSTALLATION:
18.
Slide the three spacers (722-503-097) over the three studs on top of the ground plate (254-
001-124). Remove the backing from the foam strip (252-003-117) and attach to the plate.
19.
Place the sensor board (252-003-104) over the three spacers/studs in the ground plate.
Secure the sensor board to the grounding plate by tightening the three nuts (843-121-002).
20.
Insert screws up through the two holes in the top of the bezel tunnel and through the holes
in the ends of the ground plate. Place lock nuts on top and tighten until secure. If the metal
ground plate tabs start to bend, it is too tight. Secure the ground wire to the grounding
plate with the screw as shown in Figure 21.
Figure 21, Intrusion Sensor Installation
21.
Connect the hand sensor cable (252-003-105) to the sensor board. Note the orientation of
the cable.
The end labeled with “Connect to 252-003-100” must connect to the control
box, not the sensor board.
