QubicaAMF 400288005, Installation Manual

Page: 62 / 147

Console pedestal assembly BES X installation manual
52 P/N: 400288005; Rev: L, 09/21
T.10.054 – 610325104 Kit for mounting one BES X pedestal (286002847)
1
2
3
PARTS LIST
# QTY P/N DESCRIPTION
1
2
3 1
1
5 286002848
286002849
862137200 Rear base cover FMW
Cable cover
ANCR BL 3/16 x 1.25 BC
Use this kit with pedestal 286002861 , 286002862 , 286002863 , 286002864 or 286002865 secured to floor. This kit is for the purpose of mounting one
BES X pedestal where the cable entry location is not exactly under the pedestal position.
INSTALLATION INSTRUCTIONS
1. Separate the two-piece cable cover (2).
2. Cut the cable cover base part to length as necessary to locate the cable cover on the floor between the 4HD/5HD console and the cable entry
location.
3. Remove the adhesive strip liners from the bottom of the cable cover base and secure the cable cover base part to the floor in the desired
location.
4. Drill 5/32" (4mm) holes a minimum of 1.5" (40mm) deep thru the cable cover base part into the floor close to each end and approximately every
12' (300mm).
5. Use the holes to secure the cable cover base part to the floor with anchor screws (3).
6. Install cables in the pedestal assembly and place cables in the cable cover base part.
7. Replace the existing rear base cover 286002855 from the pedestal assembly 286002861 , 286002862 , 286002863 , 286002864 or 286002865
with the rear base cover FMW 289002848 (1).
8. Routing the cables thru the opening in the rear base cover FMW.
9. Cut the cable cover top part (2) to fit snugly between the rear base cover FMW (1) and the cable entry.
10. Install the cable cover top part over the cables in the cable cover base part.