5
BEAM 7R 230W BEAM
UsER’s MAnUAl – KUllAnMA KlAvUzU
www.qube-lighting.com
1. Non-professional personnel, do not remove the fittings in lamps and lanterns without permission.
2. AC power supply: check whether the local power supply meets the rated voltage requirement.
3. The lamps and lanterns is according to the type of electric shock protection design, lamps and
lanterns should be used with sufficient power supply system grounding, and lamps and lanterns of
the ground wire must be connected to the ground of the power supply system. Do not use insulation
damaged power cord, at the same time, do not use the power cord overlap on the other wire.
4. When the installation location and lamps and lanterns, any point on the surface of lamps and
lanterns and any easy to burn the explosive keep minimum distance of 10 meters, 2.5 meters from
irradiation distance, please do not install the lamps and lanterns is directly in to burn the material
surface.
5. Ambient temperature used in luminaires: (-10 d 40 degrees), the maximum temperature
of the lamp surface is 80 degrees, and the lamps and lanterns should be kept away from the liquid
material and wet environment.
6. Make sure the lamps are well grounded before using the lamps, and do not install and remove
any parts.
7. When installing lamps and lanterns, the fixing screws must be fastened, equipped with safety
cables and checked regularly.
8. The continuous working time of the luminaires should not exceed 10 hours, and the interval time
of continuous start of the lamps shall not be less than 10. Otherwise, the bulb should be protected
from overheating and cannot be triggered normally.
9. In the process of use, the lamp should be stopped using lamps in time.
10. When the bulb reaches the rated service life, it should be replaced in time, or there will be a
dangerous explosion.
11. The rotating part of the lamp and the pasting accessories must be checked regularly and loos-
ened, and the shaking should be strengthened in time to prevent accidents.
12. Lamps and lanterns uses strong wind cooling and accumulates dirt easily. Must be cleaned once
a month especially the cooling tuyere otherwise will be in a dust jam, lead to bad heat dissipation.
Safety tips!
To ensure your safe use of lamps, read the following safety tips carefully before
using them to avoid unnecessary breakdowns and injuries.
Summary of Contents for BEAM 7R
Page 1: ...230W BEAM English...
