4
www.qube-lighting.com
BEAM 7R 230W BEAM
UsER’s MAnUAl – KUllAnMA KlAvUzU
The starting address code of the current light fixture is equal to (the initial address code of the last
light fixture) + (the number of channels of the lamp) :
1. The initial address code of the first lamp is A001.
2. The basic channel number of the controller should be greater than or equal to the total number of
use channels.
3. When using any controller, each lamp should have its own initial address code. If the initial ad-
dress code of the first light lamp is set A001, the number of the luminaire number is 16CH; The
starting address of the second light fixture is set to A017. The starting address code of the third light
fixture is set to A033; And so on and so forth, (this setting also needs to be determined by different
control tables)
This luminaire can be placed horizontally, slanting and hanging upside down, and must pay attention
to the installation method when hanging and hanging upside down.
Fixed installation of lamps and lanterns: before the positioning of lamps and lanterns, to ensure the
stability of the installation site, when the reverse hanging installation, must ensure that the lamps
and lanterns is not tumbled down on the supporting frame and handle with a safety rope through the
racks and lamps and lanterns, assist hanging; In order to ensure safety. To prevent fall and slide of
lamps and lanterns, lamps and lanterns in the installation and debugging, the ban pedestrians pass,
regularly check whether the safety rope appear wear away, whether hook screws loosen, if because
hanging installation is not stable, lead to fall all consequences arising from the lamps and lanterns
manufacturer does not assume any responsibility.
1. When replacing the bulb, remove the plastic shell of the lamphead first.
2. Good quality light bulbs are recommended.
3. Uncharged installation, remove the bulb.
4. Hand untouchable parts of the bulb.
5. Tighten the screws after replacing the bulb.
6. The light bulb work at high temperature, and gas discharge can not continue to supply the physi-
cal characteristics of bubble, must therefore be in every time, when the power is completely cooling
ability to operate in about 10 minutes, otherwise it will lead to high voltage discharge, short circuit
burn out components on the computer console.
The initial address code calculation method of lamps and lanterns:
The initial address code calculation method of lamps and lanterns:
Light bulb installation:
Summary of Contents for BEAM 7R
Page 1: ...230W BEAM English...
