Do the following to store sounds:
1.) Push [WRITE] to get into the write menu. Make sure that the right part 1- 4 is selected.
2.) Select menu page 2 of the write menu by pressing [PAGE>] The display shows:
<2> Store Sound?
[Ok]
3.)
Push [F1] to start the storage of the sound. The display shows:
Name: xxxxxxxx
[ok] [cancel]
4.)
Now you can give the sound a name. With [PAGE<>] you can select the appropriate
character position and with <VALUE> the corresponding character/special symbol. The
name can also be entered in with connected MIDI keyboard. Look in the appendix for the
character table.
5.)
If you are pleased with the name, push [F1] again. If you want to leave the menu without
storing, push [F2] then [EXIT]. In the first case the following message is in the display:
To xx (xxxxxxx)
[ok] [cancel]
6.)
With <VALUE> you can select the target memory that will be overwritten with the new
sound. The name of the designated setup will be shown on the display.
7.)
With [F1] the storage will take place, with [F2] you can still cancel storing.
8.)
With [EXIT] you can leave the write menu.
Storing a sequence
In the sequencer memory the sequence of the recently selected part will be stored. The
POLYMORPH has 50 of these memory slots. This extra memory area is for the exchange of
sequences between the single setups. The sequencer memory holds the following parameters:
a.)
Assigning the parameter to the rows Line 1-3.
b.)
The values for all steps of the rows, independent if they can be played or not.
c.)
The step muting, playing direction and cycle lengths all rows.
The parameters of the sequencer edit menu as well as the transpose settings or the resolutions will
not be stored. These settings will come into consideration when creating a new setup.
Do the following to store the sequences:
1.)
Push [WRITE] to reach the menu.
2.)
Select menu page 3 of the write menu by using [PAGE<>]. In display shows:
<2> Store seq.?
[ok]
49
The write menu
