[COMPARE] – TOGGLES BETWEEN THE ORIGINAL SOUND AND THE CHANGED SOUND
After you have been through a sound adventure tour, and do not know if your new sound is better
than the original, you can push [COMPARE] to jump back and forth between the original and your
edited sound.
[WRITE] – CALLING UP THE MEMORY MENUS
Enables the selection of the memory slot in which you will store your setups, sounds or sequences.
[PAGE<>]
- MAIN MENU: CHANGING BETWEEN SEQUENCER STEPS 1-8 AND 9-16 /
- EDIT MENU: SUB MENU SELECTION
There are various parameters available in all of the edit menus and these are spread across several
pages. To view all of these pages, simply step through them with the [PAGE<>} buttons. Pages
are numbered in the display:
|1>
You are on the first page of the edit menu. More can be found on the right of this menu.
Press [>] to go to the next page.
<9|
You are in the ninth and last page of the edit menu. More can be found on the left side of
this menu. Press [<] to go to the previous page.
<5>
You are on the fifth page of the edit menu. More can be found on the left and right of this
menu. Press [<] or [>] to reach these pages.
[EXIT] - LEAVING THE SUB MENU
To leave an edit menu, push this button.
<VALUE/TEMPO – TEMPO ADJUSTMENT / PARAMETER CHANGE
If you are not in an edit menu, this data knob controls the tempo of the sequencer. If you are in an
edit menu you can use the data knob to change the selected parameter.
<SOUND> - SOUND / SETUP SELECTIONS
This dial is for the selection of sounds or to call up complete setups. After turning on the
POLYMORPH is in the "setup" mode. A setup can be thought as a complete memory copy of the
preset settings. All parameters are saved in setups except system menus. This mode is confirmed on
the top left side of the display. "Setupxx:" is always displayed in the setup operation. When you
want to change one of the sounds, push [F1] and the POLYMORPH will go into the mode for
changing the single sound. Using [SEL. 1-4] you select the desired synth to change and with
<SOUND> you search for the desired sound. In addition you can change the sound banks with
[F1].
[START/STOP] – STARTING AND STOPPING THE SEQUENCER
With this button you can start and stop the sequences. If the sequencer does not start, check to see
if at least one sequencer is activated and if the external synchronization is turned off.
FUNCTIONS OF THE MIXER
/ TURNING SEQUENCER ON AND OFF
Mixer-Section
13
Basics
13
MIXER
MODE
MIX-VOL-1
MIX-VOL-2
MIX-VOL-3
MIX-VOL-4
SEL-1
SEL-2
SEL-3
SEL-4
UNISON
ROTATE
MULTI
STACK
MIXER
MODE
