Step 8: Enabling Communication with a Multi-Geo System
Adding a Lattus A10 to a Multi-Geo System
80
Lattus A10 Access Node Installation Guide
Connecting the A10 to
a Remote Controller
Node
To enable communication between the Lattus A10 and a Lattus
Controller Node that is not located at the same data center, follow this
procedure:
1
Shut down the local Lattus rack where the Lattus A10 is located.
2
Start the Lattus A10 and use the Lattus A10 GUI’s
Object Storage
Destinations
page to connect to the desired remote Lattus
Controller Node(s).
3
In
Centos System > Preferences > Network Connections
, change
the IP addresses on the Lattus A10 for eth5/eth7 to point to the
appropriate Lattus Controller Nodes. (Refer to
4
Restart network services on the Lattus A10.