Prism FC420 Bridge Option User’s Guide
Document 6473031-04, Ver. 4, Rel. 0
September 2003
18
Prism FC420 Services Software Commands
DisplayEvent
(Immediate)
Displays the current contents of the
event log. The log is filtered by the
current switch settings as described in
the
DispEvent
section. If the optional
all
is
selected, the display filtering is
temporarily suspended and all logged
events are displayed.
displayevent <all>
EccLog
Resets/displays the ECC error statistics
for the FC420 bridge. The
get
command
displays the statistics; the
set
command
resets the statistic counters to zero.
set ecclog clear
get ecclog
ErrorLog
Resets/displays the error logs for the
FC420 bridge. The
get
command
displays the logs; the
set
command
resets the logs to zero.
set errorlog clear
get errorlog
EthernetSpeed
Sets/displays the Ethernet speed of the
Fibre connection. If
auto
is selected, the
current speed of the connection is
indicated in parentheses in the response
to the
get ethernetspeed
command.
auto
set ethernetspeed [10 | 100 |
auto]
get ethernetspeed
Exit
(Immediate)
Exits the current Telnet command line
interface (CLI) session). This command
has no effect during a serial or in-band
CLI session.
exit
FcAck0
Specifies whether ACK0 or ACK1 will
be returned in response to a Class 2
Fibre Channel data frame or sequence.
When enabled, this option sends ACK0;
when disabled, this option sends ACK1.
disabled
set fcack0 [enabled | disabled]
get fcack0
FcClass2
Specifies whether the FC420 bridge will
support Fibre Channel Class 2
(Multiplexed) or Class 3 service.
disabled
set fcclass2 [enabled |
disabled]
get fcclass2
FcConnMode
Sets/displays the Fibre Channel
connection mode for the FC420 to
arbitrated loop or point-to-point.
Loop-ptp
and
ptp-loop
will auto-negotiate
starting with the first topology type.
ptp-loop
set fcconnmode [loop | ptp |
loop-ptp | ptp-loop]
get fcconnmode
FcDataRate
Sets/displays the data rate (in Gb/s) at
which the FC420 bridge will operate.
auto
set fcdatarate [1gb | 2gb | auto]
get fcdatarate
FcFairArb
Turns on or off the FC-AL arbitration
fairness. Applies to all three Fibre
Channel ports on each board.
enabled
set fcfairarb [enabled |
disabled]
get fcfairarb
Command
Description
Default
Syntax
