Prism FC420 Bridge Option User’s Guide
Document 6473031-04, Ver. 4, Rel. 0
September 2003
24
Prism FC420 Services Software Commands
ScsiPortSelTimeout
Show the time (msec) that the bridge
waits for a response from a SCSI device
on the selected port after a selection
request.
256 msec
set scsiportseltimeout [sb [256
| 128 | 64 | 32 | 16 | 8 | 4 | 2 | 1]]
get scsiportseltimeout [sb]
ScsiPortSyncTransfer
Specify whether synchronous SCSI
transfers should be negotiated with
devices on the specified SCSI port.
enabled
set scsiportsynctransfer [[sb]
[enabled | disabled]]
get scsiportsynctransfer [sb]
ScsiPortTaggedQueuing
Specify whether tagged command
queuing is allowed on the SCSI port.
disabled
set scsiporttaggedqueuing [sb
[enabled | disabled]]
get scsiporttaggedqueuing [sb]
ScsiPortWideTransfer
Specify whether wide SCSI transfers
should be negotiated.
enabled
set scsiportwidetransfer [sb
[enabled | disabled]]
ScsiTargets
List the SCSI devices that are on the
referenced SCSI bus.
get scsitargets [sb]
ScsiTermination
Set the internal termination of the
referenced SCSI port.
enabled
set scsitermination [sb
[enabled | disabled]]
get scsitermination [sb]
SerialNumber
Reports the FC420 bridge serial number.
get serialnumber
SerialPortBaudRate
Sets the baud rate for the FC420 serial
port (2400, 9600, 19200, 38400, 57600, or
115200).
9600
set serialportbaudrate [rate]
get serialportbaudrate
SerialPortEcho
Turn on or off echoing of keyboard
input.
disabled
set serialportecho [enabled |
disabled]
SerialPortHandshake
Set the data handshaking method used
for controlling the flow between the
transmitter and receiver (hardware,
software, or none).
none
set serialporthandshake [hard |
xon | none]
get serialporthandshake
SerialPortStopBits
Set the number of stop bits for the FC420
serial port (1 or 2).
1
set serialportstopbits [1 | 2]
get serialportstopbits
Command
Description
Default
Syntax
