Performing Initial Configuration
Quantum DXi6900-S Installation Guide
56
21. Disconnect the computer from the DXi6900-S service port. Reset the computer network settings back
to the default values.
22. Wait for the system to fully restart. This can take up to 30 minutes.
Continue with the next section to upload the new DXi software.
Uploading New DXi Software
Before configuring and using the DXi, you must upgrade to the latest available software version.
To complete the software upgrade:
1. On the service laptop, open a supported Web browser, type the IP address entered in the
Getting
Started Wizard: Network
in the
Address
box, and press
<Enter>
.
The
Login
window displays (see Figure 44 below).
Additional Information
l
For Web browsers, the DXi6900-S supports Firefox 26 or higher, Chrome 40 or higher, or
Internet Explorer 10 (with SSL 3.0 disabled) or higher.
l
If the
Login
window does not display, verify that you entered the correct IP address (
10.17.21.1
).
Also make sure that the service laptop is connected to the service port on the Node, and that the
network settings on the laptop are correct (see Accessing the Service Menu
). If the
GUI is in Limited Mode, wait ten minutes, then try again.
Figure 44:
Login Window
2. On the
Login
window, select
Administrator
, type the password you created in the Getting Started
Wizard, and click
Login
.
The
Upload New DXI Software Upgrade File
page displays (see Figure 45 on the next page).