![background image](http://html1.mh-extra.com/html/quantum/dlt-2500/dlt-2500_product-manual_3624549042.webp)
Configuring and Operating the DLT2000 Basic Tape Drive
3-4 DLT2000/DLT2500/DLT2700 Cartridge Tape Subsystem
2. Place the jumper in the disable parity check position, as shown in Letter I, Figure
3-3.
L KG-9 294 -94f
A
B
C
D
H
G
F
E
8 - Bit
I
Figure 3-3 Jumper Positions
A. SCSI ID 0
D. SCSI ID 3
G. SCSI ID 6
B. SCSI ID 1
E. SCSI ID 4
H. SCSI ID 7
C. SCSI ID 2
F. SCSI ID 5
I. Disable parity checking.
The jumper goes in this
position with any SCSI ID
you choose.
3.2.2 Changing the SCSI ID
The drive is shipped with SCSI ID 5, unless otherwise specified. You can change the
SCSI ID by adding jumpers to the drive's SCSI connector (Figure 3-1).
To change the SCSI ID:
1. Use Figure 3-1, number
, to locate the SCSI ID connector on the drive.
2. Choose a SCSI ID from 0 to 7.
3. Use Figure 3-3, to see where to place the jumpers for the ID you choose. For
example, if you chose SCSI ID 1, place the jumpers in the same positions as those
in Letter B.
Summary of Contents for DLT 2500
