Firmware Update (From Tape)
7-14 DLT2000/DLT2500/DLT2700 Cartridge Tape Subsystem
Table 7-2
Results (DLT2500 Code Update) Cont'd
If
…
…
…
…
This means
…
…
…
…
And you should
…
…
…
…
•
A
controller
failure occurs. The
drive is most likely
unusable and
needs to be
replaced.
Turn off mini-library power
and then on again.
If you still have a drive
controller failure, see your
service representative.
7.4.3 Updating the Firmware on the DLT2700 (Drive and Loader
Configuration)
1. Get or make a CompacTape with the firmware image of the desired
revision level copied to it.
2. Put the DLT2700 subsystem into firmware update mode. To do this:
a. Remove any magazine in the DLT2700 loader receiver and
close the receiver.
b. Put the Mode Select key in Service Mode (wrench icon).
c. Press the Load/Unload button on the operator control panel
(OCP) and hold the button (about 6 seconds) until the Write
Protect indicator blinks. This means the DLT2700 subsystem
has recognized your request for firmware update mode and is
waiting for completion of the sequence.
If the Write Protect indicator never blinks, check that:
1. POST succeeded
2. The drive is unloaded
3. The drive handle is in the down position
4. No magazine is in the loader
5. The receiver door is closed
6. The Mode Select key is in Service Mode
d. Then, press and release the Unload button and press the
button again within 4 seconds. The second press should be less
than 1 second.
Summary of Contents for DLT 2500
