Manual for SynactiX 5EP/5EI
Introduction
System memory
l
Provides three 168-pin 3.3V unbuffered DIMM sockets.
l
Supports 64-bit wide DIMM modules with 100/133MHz SDRAM devices.
l
Supports 32MB to 256MB SDRAM using 16MB/64MB/128MB technology.
l
Supports 512MB SDRAM using 256MB technology.
l
Supports up to three double-sided DIMMs(6 Rows) at 100MHz system memory bus.
l
Supports up to two double-sided or three single-sided DIMMs(4 Rows Max) at 133MHz
system memory bus(PC-133).
Onboard IDE
l
Supports Independent timing of up to 4 drives.
l
Supports Ultra ATA 100/66, PIO mode.
l
Implements Write Ping-Pong Buffer for faster write performance.
l
Two fast IDE interfaces supporting four IDE devices including IDE hard disks and CD-
ROM drives.
Onboard LAN (SynactiX 5EP-L/-AL, SynactiX 5EI-L/-AL available)
l
10/100 Mbit/sec Ethernet support.
l
10/100M LAN interface built-in on board.
4 USB
l
2 UHCI Host Controllers with total of 4 ports.
l
USB 1.1 compliant.
l
Supports wake-up from S1 (power on suspend), S3 (STR) (depend on device).
Onboard I/O
l
Winbond W83627HF LPC I/O chip.
l
One floppy port supporting up to two 3.5
″
or 5.25
″
floppy drives with 360K/720K/1.2M/
1.44M/2.88M format.
l
Two high speed 16550 compatible UART (COM1/COM2/COM3/COM4 selective) with
16-byte send/receive FIFO.
l
One joystick port.
l
Infrared interface.
l
All I/O ports can be enabled/disabled in the BIOS setup.
Onboard Audio(SynactiX 5EP-A/-AL, SynactiX 5EI-A/-AL available)
l
AC’97 2.1 Specification Compliant.
l
Provides onboard Line-in Jack, Microphone-in Jack, Speaker-out Jack with onboard
amplifier and MIDI/Joystick Connector.
