Qualitrol INFORMA PMD-A, User Manual

Page: 62 / 248

Installation
55
www.qualitrolcorp.com
4.4. Device Communication Settings
1. Connect the device using default communication settings of the device.
2. User can change the device communication settings in the iQ+. Refer section 5.2.6.
3. Open the configuration window and make the respective changes in the communication
port settings of Ethernet, modem and serial ports
4. Once the changes are done, user can send the configuration to the device by clicking
on the button ‘Send To Device’ in the configuration window of iQ+.
4.5. Installation Procedure
Remember the following:
• In order to ensure safe operation, first connect the device to protective earth and then
connect it to the power supply.
•
Before connecting the circuits, ensure that the maximum measuring voltage and
maximum voltage to earth are not exceeded.
• Do not use leads and accessories that do not fulfill the relevant safety standards. This
could lead to serious injury or death from electric shock.
• Make sure that the device is installed in an area where heat dissipation is not
restricted.
•
Ensure that the device is in the operating temperature range and humidity conditions
as specified in Appendix A before switching it ON.
4.5.1. Setting up the Device
1. Mount the device on the rack.
2. Connect the power cord to the 3-pin terminal block located on the rear panel of the
device.
3. The 3-pin power terminal block is labeled with L, N, and an Earth symbol. The power
cord must be connected accordingly.
4. Connect analog and digital inputs, and alarm outputs as per the specified configuration
instructions (refer to Section 3.5).
5. If a UPS card is present, ensure that the UPS is switched ON.
6. Switch on the power supply using the button located on the rear panel of the device.
4.5.2. Starting the Device
To ensure that the device has been installed correctly, the following needs to be checked.
When the INFORMA PMD-A device is powered ON, all the LEDs on the front panel must
flash in green (in anti-clock wise direction). This indicates that the device is booting up.
INFORMA PMD-A takes about 6-7 minutes for boot-up process.