Quadro PGS-H2028, User Manual

Page: 3 / 28

• Water may leak from the iron’s plate if the steam button is pressed before the boiler has
reached the optimal temperature (after about 8 minutes) or before the appliance is hot.
• Do not use the appliance if it has been dropped or damaged in any way and contact an
authorized BENRUBI Service Center.
• Do not use the appliance if there are visible signs of damage or if the iron is leaking and
contact an authorised BENRUBI Service Center.
• If the appliance is not operating normally, disconnect it from the power supply and contact
an authorized BENRUBI Service Center.
• Check the cord periodically for possible damages.
• If the supply cord or the plug is damaged, do not operate the appliance in order to avoid a
possible hazard and contact an authorized BENRUBI Service Center.
• Any repairs made by a non-authorized BENRUBI Service Centre CANCEL THE GUARANTEE.
• Do not leave the power cord hanging over the edge of the table or counter where it can be
reached by children or touching hot surfaces.
• Never leave the power cable wrapped during use. Unwind it completely.
• Always turn off the boiler and iron power switches before plugging or unplugging the
appliance.
• Do not unplug the appliance by pulling the power cord. Instead grasp the plug to disconnect
from the supply mains.
• This appliance is intended for household use only.
• Do not place the appliance on top or near any source of heat (hot gas, or electric burner or
heated oven) or on top or near surfaces where it can get wet.
ATTENTION : Before unscrewing the boiler safety cap, carry out the following steps:
- Always turn off the boiler by pressing the boiler switch to “O” position.
- Press the steam button as to let out all the residual steam.
- Turn the adjustable thermostat to MIN.
- Turn off the iron by pressing the iron switch to “O” position.
- Remove the plug from the wall socket.
- Allow the iron cool down.
- Slowly unscrew the boiler safety cap and wait for the hissing noise of the steam to stop
before unscrewing it completely.
ATTENTION : Do not move the boiler during operation.
• Always place the boiler on a stable, flat and heat resistant surface.
• Do not allow the appliance being exposed to atmospheric agents such as rain, sun, frost, etc.
• Do not leave the appliance unattended while plugged in.
• Unplug the appliance from the mains supply:
- Before filling or emptying the boiler.
- Before cleaning or maintenance operations.
- Immediately after use.
- When not in use.
• Make sure to keep the sole plate of the iron very smooth. Do not run it over metal objects
(such as against the ironing board, buttons, zips etc.)
• Never iron or dampen cloths while wearing them.
Caution : Never direct the steam jet towards other persons, as this may be extremely
dangerous.
• Do not iron very wet cloths or fabrics.
• Do not touch the appliance with wet or damp hands or feet.
• Do not use the appliance outdoors or in thebathroom.
• Do not put vinegar, any detergents or chemical substances in the boiler.
• Do not overfill the water tank and do not add stain-removers of similar products into the
water.
• Do not pure into the boiler more than 1 liter of water. Always use the filling cup provided to
fill the boiler with water. Do not exceed the MAX indication on the filling cup.
ENGLISH
- 2 -