Quadro PGS-H2028, User Manual

Page: 4 / 28

ATTENTION : To avoid the risk of overflow, do not pure into the boiler more than 1 litre of
water.
ATTENTION : Do not fill the appliance under a running tap.
• Always place the iron on the heat resistant base. Never allow the iron to stand vertically on
its base.
• The steam generator is installed with a magnetic device. The appliance may not function
correctly when located near a strong electromagnetic field. When you use and store the
steam generator, please keep it away from any electromagnetic field (e.g. Television).
WARNING : Never remove the boiler safety cap while the steam generator is operating or it
is plugged into the main supply.
WARNING : If you find any steam escaping from boiler safety cap, switch off the appliance
immediately and remove the power cord from the mains supply. After the appliance has
cooled down completely, remove the safety cap. Then screw it back into place. If the steam
still escapes even after the above procedure has been followed, switch off the appliance,
remove the power cord from the supply mains and contact an authorized BENRUBI Service
Centre.
WARNING : Never unscrew the boiler safety cap before the steam generator has completely
cool down.
CAUTION : To ensure best results and allow the appliance to last longer, rinse out the boiler
after every 10 times of use.
• Use only genuine accessories and spare parts as recommended by the supplier. Only replace
the boiler cap containing the safety device (calibrated) with another original spare part.
• Store the unit out of the reach of children.
• Should you decide not to use the appliance again, remove the plug from the socket and cut
the supply cable to render the appliance completely inoperative.
• For your safety, this appliance conforms to the applicable standards, regulations and
directives for Low Voltage, Electromagnetic Compatibility, Environmental etc.
SAVE THESE INSTRUCTIONS
ENGLISH
- 3 -