June 18, 2014
7082-132C
7
MT. VERNON E2 INSERT
*BTU will vary, depending on the type of fuel you use in your
appliance. Consult your Quadra-Fire dealer for best results.
C. Glass Specifi cations
This stove is equipped with 5mm ceramic glass. Replace
glass only with 5mm ceramic glass. Please contact your
dealer for replacement glass.
D. Electrical Rating
115 VAC, 60 Hz, Start 2.9 Amps, Run 2.45 Amps
The Quadra-Fire Mt. Vernon E2 Insert Pellet Stove meets
the U.S. Environmental Protection Agency’s 1990 particulate
emission standards.
Model
Mt. Vernon E2 Pellet Insert
Laboratory
OMNI Test Laboratories, Inc.
Report No.
061-S-84-2
Type
Solid Fuel Room Heater and Pellet Fuel
Burning Type
Standard
ASTM E1509-12, ULC S628-93 and
84-HUD, Mobile Home Approved.
FCC
Complies with Part 15 of FCC Rules.
Operation is subject to the following two
conditions: (1) this device may not cause
harmful interference, and (2) this device
must accept any interference received,
including interference that may cause
undesired operation.
EPA Certifi ed:
1.7 grams per hour low
2.7 grams weighted average
Effi ciency (LHV):
Up to 87%
BTU Input:
18,000 to 52,500
BTU Output:
13,800 to 37,600
Heating Capacity:
Up to 3,000 sq ft depending
on climate zone
Vent Size:
3” or 4” Type ‘L’ or ‘PL’
Fuel:
Wood Pellets
Shipping Weight:
510 lbs
• Installation and use of any damaged appliance.
• Modifi cation of the appliance.
• Installation other than as instructed by Hearth & Home
Technologies.
• Installation and/or use of any component part not approved by
Hearth & Home Technologies.
• Operating appliance without fully assembling all components.
• Operating appliance without legs attached (if supplied with unit).
• Do NOT Overfi re - If appliance or chimney connector glows,
you are overfi ring.
Any such action that may cause a fi re hazard.
1
Listing and Code Approvals
A. Appliance Certifi cation
NOTE: Hearth & Home Technologies, manufacturer of
this appliance, reserves the right to alter its products, their
specifi cations and/or price without notice.
NOTICE:
This installation must conform with local codes. In
the absence of local codes you must comply with the
ASTM
E1059-12, ULC S628-93, (UM) 84-HUD and ULC/ORD-
C-1482.
Improper installation, adjustment, alteration, service or
maintenance can cause injury or property damage.
For assistance or additional information, consult a qualifi ed
installer, service agency or your dealer.
Quadra-Fire is a registered trademark of Hearth & Home
Technologies.
WARNING
Fire Risk.
Hearth & Home Technologies disclaims any
responsibility for, and the warranty will be voided by,
the following actions:
B. BTU & Effi ciency Specifi cations
E. Mobile Home Approved
•
This appliance is approved for mobile home installa-
tions when not installed in a sleeping room and when
an outside combustion air inlet is provided.
•
The structural integrity of the mobile home fl oor, ceil-
ing, and walls must be maintained.
•
The appliance must be properly grounded to the
frame of the mobile home and use only Listed pellet
vent Class “L” or “PL” connector pipe.
•
Outside Air Kit (OAK-3) must be installed in a mobile
home installation.
