Grand Bay 40 Direct Vent Freestanding
Page 4
January 2000
SAFETY NOTICES
This stove should be installed only by a qualified installer. It is approved for installation in a bedroom.
Bedroom installation in Canada requires that the stove be connected to a thermostat. The stove must be
electrically grounded in accordance with local codes, or the latest edition of the National Electric Code. If
no local codes exist, this stove should be installed following the current codes:
CAN/CGA-B149.1 ........................................................................ Natural Gas Installation Code
CSA-C22.1 .................................................................................... Canadian Electrical Code
ANSI Z223.1 ................................................................................. National Fuel Gas Code
ANSI NFPA-70 ............................................................................. National Electrical Code
Manufactured (mobile) home installation must conform to the manufactured home construction and safety
standard (UL307B, Title 24 CFR, Part 3280), or when such a standard is not applicable, the standard for
manufactured home installations (ANSI A225.1/NFPA 501A).
The control compartment, burner, and circulating air passageways MUST be kept clean and clear to allow
for adequate combustion and proper operation. Provide adequate clearances around air openings and adequate
accessibility clearance for service and operation. NEVER obstruct the openings of the stove or the vent
termination on the exterior of the building. NEVER vent the stove to other rooms or buildings; this stove
must be vented ONLY to the outside. During installation, be sure to maintain minimum clearances to
combustibles, as shown on page 7. Always contact your local building department or fire department prior
to installing this stove. If required, obtain a permit before installing, and have the completed installation
inspected. Failure to do this could jeopardize your homeowners insurance.
The area around the stove MUST be kept free from combustible materials, gasoline and other flammable
vapors and liquids. This stove is hot during operation, and should be located out of heavy traffic areas and
away from furniture and draperies. Clothing or other flammable material should not be placed on or near the
stove. Children and adults should be alerted to the hazards of high surface temperatures and should stay
away to avoid burns or clothing ignition. Children should not be left unsupervised in the room when this
stove is in operation.
If any part of this stove has been under water, DO NOT USE it!! Immediately call a qualified service
technician to inspect the stove, and to replace any part of the control system or any gas control which has
been under water.
This stove should NOT be modified under any circumstances. Any parts removed for servicing must be
replaced before operating this stove. Installation and repair should only be done by a qualified service
technician. The stove and its venting system should be inspected and cleaned annually by a qualified service
technician. More frequent cleaning may be necessary due to excess lint and dust from carpeting, bedding
material, etc. Be sure to turn off gas valve and pilot before cleaning this stove.
Install at least one smoke detector on each floor of your home to ensure your safety. They should be located
away from the gas stove and close to the sleeping areas. Follow the smoke detector manufacturers placement
and installation instructions, and be sure to maintain regularly. Your local fire department may provide
assistance in selecting smoke detectors, or contact the Consumer Product Safety Commission, Washington,
D.C. 20207.
WARNING:
Do not operate appliance with the glass front removed, cracked or broken. Replacement of
the glass should be done by a licensed or qualified service person.
SAFETY NOTICES
