27
7027-802C
June 4, 2019
CB1200 Free Standing
C. Igniter Replacement
PART NUMBER:
SRV7000-462
1. Use proper shut down procedures to shut down the
appliance and let it completely cool down and then
unplug it and remove the ash drawer.
2. Follow instructions to remove the ash pan found on
page 19 - Cleaning Ash Pan
. Remove the access
plate directly above it by removing the 2 screws just
below the ash catcher.
3. The wire leads to the igniter are connected to the wire
harness with 1/4 inch male / female spade connectors.
These wires will pull forward approximately 4 to 5
inches (102mm to 127mm). Disconnect the spade
connections and remove the igniter from the chamber.
Loosen the thumb screw and slide igniter out.
4.
Install new igniter into the chamber and tighten the
thumb screw. Re-connect the wires to the 2 leads with
the spade connectors.
5.
Remove right side panel and pull wire leads back
toward the rear of the appliance to take-up the 4 to 5
inches (102mm to 107mm) previously pulled out. This
will keep the wires out of the way of the ash drawer.
Double check that the igniter wires are clear of any
movement, i.e. ash drawer, fire pot cleaning rod, etc.
6. Re-install the ash drawer and side panel and re-
connect the power.
Igniter
Igniter Bracket
Thumb Screw
Figure 28.1
Shock Risk
.
•
Do NOT remove grounding prong
from plug.
• Plug directly into properly grounded 3
prong receptacle.
• Route cord away from appliance.
•
Do NOT route cord under or in front
of appliance.
CAUTION
B. Baffle Replacement
PART NUMBERS:
LEFT BAFFLE:
510-5350
RIGHT BAFFLE:
510-5360
1. Use proper shut down procedures to shut down the
appliance and let it completely cool down.
2.
Open right side panel and then open the door.
3.
The 2 baffles are located at the top inside of firebox.
4.
Place your hand on the baffle and slide it up and the
bottom edge will fall down and then you can lift the
baffle out. Repeat for the other side.
a.
Remove Baffle to Access Heat Exchanger
Tubes and Firebox Exhaust Exits
i.
Open the upper right side panel door and then
open the glass door.
ii.
The 2 baffles are located at the top inside
of firebox.
iii.
Place your hand on the baffle and slide it up
and the bottom edge will fall down and then
you can lift the baffle out. Repeat for the
other side.
iv. Re-install in reverse order.
