11
7027-802K
10/21
Figure 11.1
Fuel Adjustment
Rod
Thumb
Screw
Set Screw
J. Feed Rate Adjustment Instructions
The feed adjustment control rod is factory set, and should
be adequate for most fuels. The set screw is located at the
bottom of the hopper and
set loose at the factory
so the
fuel adjustment control rod will slide up and down by only
loosening the thumb screw at the top (
Figure 11.1).
Do not
re-tighten bottom set screw.
However, if the flame height is too high or too low, you will
need to adjust the feed rate. Wait until the appliance has
been burning for 15 minutes before making your adjustments
and allow 15 minutes for feed adjustment to take effect.
1. Loosen the thumb screw (
Figure 11.1).
2. Adjust the fuel adjustment control rod upwards to
increase the feed rate and flame height or downwards to
decrease the feed rate and flame height.
3. Re-tighten the thumb screw.
3. Occasionally the appliance may run out of fuel and shut
itself down. When this happens, the red call light will be
on (
See Figure 10.1
on
. To restart it, fill the
hopper and press the reset button (
Figure 10.1 on page
10).
When you press the reset button the red call light will
go out. Release the button and the light will come back
on. You should see a fire shortly. If not, follow
Starting
Your First Fire
L. Restarting the Appliance
Restart Process
1. When the unit has run out of fuel, add pellet fuel to
the hopper.
2. Dump the ashes and clinkers built up in the fire pot by
pulling the ash dump removal handle out several times.
Make sure clinkers have dropped into the ash pan then
return the handle to fully closed position.
3. Press the reset button; the appliance will then being its
startup sequence.
Restarting After a Power Failure
1. For an electrical disruption the appliance will start on
its own without need for priming - providing the control
system is asking for heat.
Hot while in operation. Keep children, clothing and
furniture away. Contact may cause skin burns.
CAUTION
WARNING
Fire Risk
Do NOT operate appliance:
•
With appliance door open.
•
Fire pot floor open.
•
Cleaning slide plates open.
Do NOT store fuel:
•
Closer than required clearances to combustibles to
appliance.
•
Within space required for loading or ash removal.
K. Ignition Cycles
1. At the beginning of each ignition cycle, it is normal to see
some smoke in the firebox. The smoke will stop once the
fire starts.
2. The convection blower will automatically turn on after
your appliance has been burning for approximately 10
minutes. This blower transfers heat from your appliance
into the room, and will continue to run after the thermostat
has stopped calling for heat until the appliance has
cooled down.
