Quaddrix QT-220EX, User Manual

Page: 57 / 69

• Hard ID : Hard ID is set via DIP SW1. It cannot be changed from the OSD
menu. Hard ID range from 1 to 255.
• Programmable ID : Set all the 8bits of the SW1 to ON to activate the soft
address. Input the 10-bit camera SN number, and then set the Dome ID
through the controller (The SN number can be found on the side of the dome or
on the package).
• Debug ID : Set the SW1 to 0 (all OFF), the dome will react to any command for
any ID.
NOTE: Debug ID only works with the Factory Protocol.
• Broadcast ID : When a command is sent to a broadcast ID, all domes
connected to the control bus will respond to that command. Broadcast ID is
definable and ranges from 1 to 255. The default broadcast ID is 255.
SW1 is for dome ID setting. The setting is strictly according to the binary system.
If you are not familiar with the binary system please refer to the address setting
chart.
NOTE:
When using Philips protocol, the first 5 bits of the SW2 and all bits of the
SW1 are for address setting. The max address is 8191. For example: in order to set
address 2657, set bit 1, 6, 7 of SW1 and bit 2, 4 of SW2 ON.
(2657=1+32+64+512+2048)
57