25
4. Install Housing.
Put the cables through the top hole of the housing, and
then turn the housing thread pipe head into the pole
bracket and fasten the connection with an M4 screw.
Apply water-proof tape to the housing thread.
NOTE:
Apply silica gel to the gap between bracket
and the base in the case of outdoor dome.
5. Connect cables.
Plug the cables into the corresponding
sockets board. When finished, tighten the
circuit and turn the power On. The red LED
Off the power after checking.
NOTE:
Please make is off before doing
connections.
6. Set Dome ID, Baud Rate and
Protocol.
Set dome ID, baud rate and protocol via
DIP switches (Refer to APPENDIX I).
Take the two sponges off.
Summary of Contents for QT-220EX
