7
154.091UK User Manual
3.3 Programming
A program (bank) is a sequence of different scenes (or steps) that will be called up one after another.
In the DM-X10, 30 programs can be created with 8 scenes in each.
3.3.1 Entering Program Mode
Press the
Program
button until the LED blinks.
3.3.2 Create a Scene
A scene is a static lighting state. Scenes are stored in banks. There are 30 bank memories on the controller
and each bank can hold 8 scene memories. The DM-X10 can save 240 scenes total.
Action
1.
Press and hold the
PROGRAM
button until the LED blinks.
2.
Position
SPEED
and
FADE TIME
sliders all the way down.
3.
Select
FIXTURE(S)
to begin adjusting the DMX values
4.
Move faders to adjust parameters to the required setting for the fixture(s)
5.
De-select a fixture to hold its DMX values
6.
Adjust for all fixtures until all are set at the required state
7.
Press the
MIDI/ADD
button
8.
Select a
BANK
and then select a
SCENE
to store the scene
9.
Press
PROGRAM
to store
10.
Repeat the above process for up to 8 scenes in the bank
11.
Hold the
PROGRAM
button to exit Program mode
Notes:
Deselect
BLACKOUT
if LED is lit.
Toggle the
PAGE SELECT
button to access channels 9-16
All LEDs flash to confirm storing a scene
Shortcut: Press [
PROGRAM
] [
FIXTURES
] Adjust [
Faders
] [
BANK
] [
SCENE
] Press [
PROGRAM
] to store.
3.3.3 Running a Program
Action:
1.
Use
BANK UP/DOWN
buttons to change Program banks if necessary
2.
Press the
AUTO DEL
button repeatedly until the AUTO
LED turns on
3.
Adjust the program
speed via the
SPEED
fader and the loop rate via the
FADE TIME
fader.
4.
Alternatively you can tap the
TAP DISPLAY
button twice.
The time between two taps sets the time between SCENES (up to 10 minutes)
Note: Deselect Blackout if LED is lit.
3.3.4 Check Program
Action:
1.
Press and hold the
PROGRAM
button until the LED blinks
2.
Use
BANK UP/DOWN
buttons to change Program bank to review
3.
Press the
SCENES
buttons to review each scene individually
