Page
40
AN-X4-ABRIO-HMI
Feb 2023
You must enter a valid default gateway address even if there is no device at the gateway address on
the network.
Factory
Select Factory to return AN-X to its initial state as shipped. In Factory mode, the AN-X waits 10
seconds for a DHCP server to assign it an IP address. If it fails to obtain an IP address, it reverts to a
static IP address of 192.168.0.246.
In Factory mode, AN-X cannot connect to the remote I/O network.
If, after AN-X has reverted to the static address and a DHCP server comes online, AN-X obtains an
IP address from the DHCP server.
Hostname
Enter a
Hostname
for the AN-X4. This name is used internally by AN-X and may be used to identify
the AN-X if you have a DNS server on your network. The name can be from 1 to 30 characters long.
The default hostname is ANXxxxxxx, where xxxxxx is the serial number of the AN-X module.
AN-X Firmware Select
Use
Administration/AN-X Firmware Select
to select a firmware (*.qtf) file the AN-X is to run from
the list. AN-X builds the list from the firmware files on the microSD card that are compatible with
the AN-X hardware.
Click SUBMIT to run the firmware you have selected. You must REBOOT the AN-X to run the
firmware you selected.
AN-X Firmware Upload
Use
Administration/AN-X Firmware Upload
to upload a firmware (*.qtf) file to the AN-X.
Uploading a qtf file automatically selects the file. You must REBOOT the AN-X to run the firmware
you uploaded.
WARNING!
Updating the AN-X firmware will disrupt RIO and Ethernet
communication. Make sure your process is in a safe state.
AN-X Firmware Remove
Use
Administration/AN-X Firmware Remove
to remove a firmware (*.qtf) file from the AN-X.
You cannot remove the file that is currently running on the AN-X.
AN-X Diagnostic Capture
Use
Administration/AN-X Diagnostic Capture
to create a zip file that contains the current AN-X
configuration and logs, for use by technical support.
