QSW-6200
Series Switch Hardware Installation and Reference Guide
38
www.qtech.ru
Setting Terminal Parameters
Step 1: Start the PC and run the terminal simulation program on the PC, such as Terminal on Windows 3.1 or
HyperTerminal on Windows 95/98/NT/2000/XP.
Step 2: Set terminal parameters. The parameters are as follows: baud rate 9600, data bit 8, parity check none, stop bit 1,
and flow control as none.
Choose Setup > Program > Attachment > Communication > Super Terminal.
Choose
Cancel
to display the following page.
Figure 4-2
Enter the name of the new connection and click
OK
to display the following page. Choose the series port used currently in
the column [use when connecting].
Figure 4-3
