9
LAB A / PoE
LAB
B
1
Free-Standing Installation
1.
Perform the steps in “Prepare for Installation (both
options)” on page 7. Refer to
Figure 11
2.
Remove the Cable Cover (2) from the
Galaxy (1). Refer to
Figure 12
3.
Connect the cables to the proper connectors in the Galaxy
a.
LAN A/PoE - required for network. (PoE is optional if you use the
12V DC AUX Power)
b.
LAN B - optional (for redundant network)
c.
12V DC AUX Power input - optional (required if you are not using
PoE)
4.
Carefully route the cables as shown.
—
Figure 11
—
NOTE:
Some cables may have a protective boot over the RJ45 connector. The boots may not fit into the
Galaxy cable cavity.
Refer to
Figure 13
EN
5.
Carefully place the Base (1) onto the Galaxy body (2). Make sure the cables are not pinched.
6.
Secure the Base to the Galaxy
with the 4 screws (3) removed in “Prepare for Installation (both options)”.
3
1
USB
Refer to
Figure 14
(1)
USB 2.0 Micro-AB
interface
— Figure 12 —
2
— Figure 13 —
— Figure 14 —
1
2