8
LAN A/PoE LAN
B
12V DC
EN
Through-the-Table Mounting
1.
Drill a 33.3 mm (1-5/16 inch) hole through the mounting surface in the spot
where you want to mount the Galaxy.
Refer to
Figure 6
2.
Screw end with fewer threads on Mounting Pipe (1) into the bottom
side of the Base (2). Refer to
Figure 7
3.
Run the cables (1) through the Nut (2), Washer (3), mounting surface (4),
and Mounting Pipe/ Base assembly (5)
Refer to
Figure 8
4.
Connect the cables to the proper connectors in the Galaxy
a.
LAN A/PoE - required for network. (PoE is optional if you use the 12V DC
AUX Power source)
b.
LAN B - optional (for redundant network)
c.
12V DC AUX Power input - optional (required if you are
not using PoE) Refer to
Figure 9
NOTE:
If the Cable Cover (3) fell off during disassembly, be sure to
replace it before re- installing the Base (1).
5.
Carefully place the Base (1) onto the Galaxy body (2). Make sure the cables
are not pinched.
6.
Secure the Base to the Galaxy
with the 4 screws (3) removed in “Prepare
for Installation (both options)”.
Refer to
Figure 10
7.
Feed the cables (1) through the mounting surface (2) along with the Mounting
Pipe (3).
8.
Move the Washer (4) onto the Mounting Pipe (3), then thread the Nut (5) onto
the Mounting Pipe.
9.
Tighten the Nut (5) as needed.
—
Figure 6
—
—
Figure 7
—
3
1
a
b
c
2
4
— Figure 8 —
5
— Figure 10
— Figure 9 —
