7
1
2
3
Installation
The Z-SYS Galaxy is designed to be mounted on a
table, or desk.
General Requirements
The Galaxy
•
Must have access to the Z-LAN Ethernet.
•
Must be mounted with sufficient space for
adequate ventilation.
•
Mounting surface Thickness:
•
Maximum
– 4” (102 mm),
•
Minimum
– Not specified
Power Source
•
PoE (Power over Ethernet
– IEEE 802.3af class 3 device) LAN A
only
•
12V DC AUX Power source (not supplied)
◦ 12V DC @ 1A (12W)
◦
Barrel connector:
» Negative contact
– 5.5mm +/- 0.2mm
» Positive contact
– 2.5mm +/- 0.2mm
» Length - 9.5mm +/- 0.3mm
Installation Configuration
Select one of the following:
1.
Through the Table Mounting (
Figure 3
)
a.
Galaxy
2.
Free Standing (
Figure 4
)
a.
Galaxy
b.
Mounting Surface (table, desk...)
b.
Mounting Surface (table, desk...)
EN
c.
Mounting Pipe - 31.6 mm (1.25 in), Nut and
Washer
d.
Galaxy Cables - through the table
c. Galaxy Cables - over the table
a
b
c
d
— Figure 4 —
— Figure 3 —
Prepare for Installation (both options)
Refer to
Figure 5
1.
Remove the Galaxy from the box.
2.
Remove 4 screws (1) from the bottom of the assembly. Save for later use.
3.
Remove the Base (2).
NOTE:
If the Cable Cover (3) falls off during disassembly, be sure
to replace it before re-installing the Base (2).
— Figure 5 —
