Gigabit Network QoS Router
43
first WAN. When other WANs (WAN2, WAN3, or WAN4) are broken and connection error remove
(Remove the Connection) has been selected for the connection detection system, traffic will be shifted
to the first WAN (WAN1). In addition, if the first WAN (WAN1) is broken, the traffic will be shifted to other
WANs in turn. For example, the traffic will be shifted to WAN2 first; if WAN2 is broken too, the traffic will
be shifted to WAN3, and so on.
6.2.3 Protocol Binding
Interface Configuration
GIGABIT Router allows maximum four WAN interface, the bandwidth and real connection of every WAN
will impact the laod balance mechanism, therefore you need to set the Bandwidth and the Network service
detection by each WAN Port correctly.
In
“Interface Configuration”
, click
“Edit”
to enter the WAN port configuration.
Bandwidth Configuration
When Auto Load Balance mode is selected, the device will select sessions or IP and the WAN bandwidth
will automatically allocate connections to achieve load balancing for external connections. The network
bandwidth is set by what users input for it. For example, if the upload bandwidth of both WANs is 512Kbit/sec,
the automatic load ratio will be 1:1; if one of the upload bandwidths is 1024Kbit/sec, while the other is
512Kbit/sec, the automatic load ratio will be 2:1. Therefore, to ensure that the device can balance the actual
network load, please input real upload and download bandwidths. The section refers to QoS configuration.
Therefore, it should be set in QoS page. Please refer to 8.1 QoS bandwidth configuration.
Protocol Binding
Users can define specific IP addresses or specific application service ports to go through a user-assigned
