4. Basic Operations
This chapter describes basic NAS operations.
Power Button
Operation
User Action
Result
Power on
Press the button once.
The device powers on.
Power off
Press and hold the button for 1.5
seconds.
The device powers off.
Force power off
Press and hold the button for 5
seconds.
The device powers off.
Important
Use this method only
when the device is
unresponsive.
Reset Button
Operation
User Action
Result
Basic system reset
Press and hold the
button for 3 seconds.
The following settings are reset to default:
• System administrator password: MAC address of
adapter 1 without special characters. For example, if
the MAC address of adapter 1 is 11:22:33:44:55:66,
then the admin password will be 112233445566.
Tip
You can find the MAC address of adapter 1
using Qfinder Pro. A label attached to the
device also lists the address as MAC1.
• TCP/IP configuration:
• Obtain IP address settings automatically via
DHCP
• Disable jumbo frames
• If port trunking is enabled (multi-LAN models
only), the port trunking mode is reset to “Active
Backup (Failover)”.
• System port: 8080 (system service port)
• Security level: Low (Allow all connections)
• LCD panel password: (blank)
• VLAN: Disabled
Advanced system
reset
Press and hold the
button for 15 seconds.
The default factory settings are restored.
• To retrieve old data after an advanced system reset,
recreate the previous folder structure on the NAS.
TS-hx86 User Guide
Basic Operations
48
