&RQILJXUHWKH
1HWZRUN
&RQQHFWLQJWRDQ(WKHUQHW1HWZRUN
&RQILJXUHWKH1HWZRUN
Unless you are using TCP/IP, it is not necessary to do this right now.
You can configure the network after the printer is up and running.
For complete instructions, refer to the
QMS CrownNet Setup Guide.
7&3,31HW:RUN&RQILJXUDWLRQ
1
Log on the UNIX system as root.
2
Edit the system host table by adding the following line to the
/etc/hosts file:
internetaddress hostname
where
internetaddress is the Internet address of the printer
(Administration/Communications/Network2/CrownNet/TCPIP/
Internet Address menu) and
hostname is the name of the host.
3
If necessary, set the hardware address.
V
Caution:
We strongly recommend that you do not change the
hardware address.
If you’re working on a system other than a UNIX system, set
the hardware address through the printer control panel.
If you’re working on a UNIX system, send the hardware
address to the print server by typing
arp -s
hostname hardwareaddress temp
↵
ping
hostname
↵
where
hostname is the name of the host and hardwaread-
dress is the hardware address of the printer (in the form
##.##.##.## as found on the printer start-up page).
»
Note:
You can also send the hardware address of a UNIX
system through the BOOTP and RARP utilities.
