D3D D3DONEPRO First Setup Manual Download Page 1

Page: 1 / 6

FIRST SETUP D3DONEPRO

1: grab the cardboard box with both hands and slide from the top to remove it completely.

2: remove the protective polystyrene panel

3: remove the four (4) protections located at the four corners of the 3D Printer

4: lift the 3D printer using the two handles located on left and right sides

Summary of Contents for D3DONEPRO

Page 1: ...both hands and slide from the top to remove it completely 2 remove the protective polystyrene panel 3 remove the four 4 protections located at the four corners of the 3D Printer 4 lift the 3D printer using the two handles located on left and right sides ...

Page 2: ...n the lower part of the 3D Printer 7 remove the box located in the lower part of the 3D Printer WARNING If the box is too much tight with the bed you can lift up the bed manually with barrel move the box a bit in front right and you can touch down on the back like the photo rotating it from left to right like clock rotation ...

Page 3: ...rs of the bed 10 open the box that you removed from the printer earlier and check that you can find inside 1 HS PLA Spool 1 Spool holder 1 power supply cable 1 USB Cable 1 Bondtech feeder 1 SD card Mixed Tools 11 insert the bowden tube in the head like in photo Push it inside approximatively 5 cm until you touch the base ...

Page 6: ......