Qlogic iSR6200, Software Manual

Page: 56 / 210

5–Performing Data Migration
Setting Array Properties
5-8 ISR654608-00 B
To map a Fibre Channel initiator to a LUN:
1. On the Wizards menu, click Presentation Wizard to open the Target
Presentation/LUN Mapping Wizard.
2. On the Select the Initiators for the LUN Presentation window, select one or
more Fibre Channel initiators, and then click
Next .
3. On the LUN Selection window, select one or more LUNs for the selected
virtual port group node, and then click
Next .
4. On the Portal Selection window, the router automatically detect the portals
through which the array target ports are accessible. Select a portal to use for
target mapping (or
None ), and the click Next .
The LUN Masking Configuration Status opens, and the Security Check
dialog box prompts you to enter the
admin password.
5. Type the admin password, and then click Next .
6. On the LUN Masking Configuration Status window, review the results of the
target ports presented for the selected initiators, and then click
Finish .
Setting Array Properties
SANsurfer iSCSI/FC Router Manager enables you to configure the target type and
bandwidth, and to enable load balancing, for each storage array used in data
migration.
To set array properties:
1. In the left pane, click Arrays to view all the Fibre Channel storage arrays
detected by the iSR6200.
2. Click the storage array you want to use as the source array.
The Information page in the right pane displays all the properties currently
set for the selected array.
Figure 5-1 shows an example.
NOTE:
The Portal Selection window appears only when there is no existing
mapping. This window does not appear if the target map is created
separately using the Target Map Wizard, or if it exists as part of a
previous LUN presentation through this array.