Qlogic iSR6200, Software Manual

Page: 117 / 210

6–Command Line Interface
set array
ISR654608-00 B 6-43
set array
Sets the target type of an array to make it behave as either a source, a
destination, or both.
Authority
miguser
Examples
The following example shows the
set array
command:
iSR6200 <1> (miguser) #> set array
A list of attributes with formatting and current values will follow.
Enter a new value or simply press the ENTER key to accept the current value.
If you wish to terminate this process before reaching the end of the list
press 'q' or 'Q' and the ENTER key to do so.
Index WWPN, PortId Symbolic Name Target Type
----- --------------------------------- --------------- -----------
0 20:78:00:c0:ff:d5:9a:05, 00-00-00 HP MSA2012fc-0 Src+Dest
1 50:00:1f:e1:50:0a:e1:49, 82-07-00 HP HSV200-1 Src+Dest
2 50:06:01:60:4b:a0:35:de, 82-03-00 DGC RAID-2 Src+Dest
3 50:00:1f:e1:50:0a:37:18, 00-00-00 HP HSV210-3 Src+Dest
Please select a Target Id from the list above ('q' to quit): 0
Symbolic Name (Max = 128 characters) [HP MSA2012fc-0]
Target Type (1=SrcTarget, 2=DstTarget, 3=Src+Dest 4=None Target) [3 ]
Bandwidth for Migration (0=Array Bandwidth, 50-1600 MBps ) [0 ]
Enable Load Balancing (0=Enable, 1=Disable) [Enabled ]
Array based licensed applied.
All attribute values for that have been changed will now be saved.
Follow these steps to change the array properties using the CLI. Note that all data
migration operations are authorized only to the migration administrator session,
miguser . For more information, see “Miguser Session” on page 6-2 .
To set array properties in the CLI:
1. Log in to the iSR6200 as guest and enter the password.
2. Open a miguser session using the following command:
miguser start -p migration
(The default password for miguser is migration .)
3. To access the array properties, enter the following command:
set array