16
– 12|2017 – Subject to change.
Speedkid2 2018
Assembly
Optional assembly steps
Installing the buggy wheel
You need the buggy wheel for Buggy and Walker mode. Das Buggy-Rad wird direkt mit der am
Rahmen befestigten Radaufhängung verbunden und ist um 360° drehbar gelagert.
f
Lift the cabin at the front.
f
Place the buggy wheel into the wheel mount as far as
it will go, until it engages audibly with a clicking noise.
f
Check whether there is sufficient air in the buggy
wheel (maximum air pressure: 1.9 bar).
If necessary, use an air pump for car valves to top up
with air.
Buggy-Rad einstellen
f
Set with the mode selector switch
[A]
and the release
button (unlock key)
[B]
in front of the suspension the
desired operating mode:
–
Buggy mode: Buggy wheel rotatable through 360 °.
–
Walker mode: Buggy wheel running straight.
–
Trailer mode: unfasten and pull out the buggy
wheel.
Mounting the tow bar
You only require the tow bar in Trailer mode. It is used to hook up the
Speedkid2
behind a bicycle
equipped with a suitable coupler, see
„Connecting the trailer to a bicycle“ on page 25
.
The tow bar is attached to the tow bar mount using a locking bolt and can be used in two different
positions:
Attachment position: The tow bar is facing forwards.
Standby position: The tow bar is facing to the rear and is carried under the cabin floor.
In both positions, the tow bar is also secured with a cotter pin.
f
Pull the locking knob and turn about 30 ° so that the
button during the release remains in the open position.
f
Push the front button on the tow bar so that the locking
bolt unlocks.
f
Keep on pushing down the button and push the tow
bar forwards until the mark in the tow bar mount is
reached.
f
Release the button so that the locking bolt secures the tow bar in the tow bar mount.
f
Additionally, secure the tow bar by pulling the locking knob slightly backwards, turn about 30 °
and let it return to the closed position.
