Speedkid2 2018
Subject to change. 12|2017 –
15
Assembly
f
Tilt back the cabin and place it on its reverse side. This
makes the lower cabin frame accessible for assembly.
f
Tighten the two harnesses that run in the direction of
travel so that the backrest is fixed.
The belt, with which the textile covering of the cabin is
fixed, runs under the cabin floor across to the direction:
f
Tighten this belt as well.
f
Put the ends of the belt straps through the buckles to
stow them.
Inserting the pennant
Danger!
The pennant must always be mounted in Trailer mode. Otherwise the very low
Speedkid2
is too easily not seen by other road users.
For safety reasons, we recommend putting the pennant into the pennant pouch so
that it is easily visible before every journey, including in Buggy or Walker mode.
f
Using the connecting piece, connect the pennant staff
to the extension rod.
f
Fit the pennant on the left outside of the
Speedkid2
:
–
Guide the extended pennant staff through the loop
at the top left on the cover.
–
Insert the end of the pennant staff into the pennant
pouch located below.
f
Unroll the pennant so that it can fly clearly visible on the pennant staff.
Mounting the brake pedal
f
Loosen the screws on the brake lever holder of the
axle using a hexagon socket wrench of the size 5.
f
Insert the brake pedal into the receptacle.
f
Fix the previously loosened screws.
